View Single Post
      12-04-2012, 05:01 PM   #5
Private First Class

Drives: 335d
Join Date: May 2011
Location: Durham, NC

iTrader: (0)

All installed. I got the cover off without too much of a problem, but I could not get the rear left screw back in. Not sure what is going on there. It just won't get threaded for some reason. Not a big deal as the other 4 went back in just fine.

I zipped tied it and I think it's all good. Do I need to be concerned about heat near the wire connectors? They're just sitting on the engine block there. Seems like a less than ideal place for them. And where the heck is the adjustment dial? I couldn't find it anywhere.