View Single Post
      12-07-2012, 08:48 AM   #1
JamesM3M5
Some dude
 
Drives: E28 M5, E92 335i
Join Date: Sep 2011
Location: Northern VA

Posts: 1,647
iTrader: (0)

Previously working meth kit, now low flow

Running the Vishnu PWM meth setup for over a year now, and it has been 99% flawless. I've had to trim back the hoses going into the push-connect fittings on the pump (no leaks, just being proactive), and had to retighten the connections on the small filter due to sucking air.

Anyway, went out of town and didn't drive the car for a whole 3 days, and it's now acting up. Meth flow is poor, and I don't see any bubbles in the clear tubes that run to the jets, just solid fluid. I've jumped the pressure switch and purged the system 3 times, checked all connections for leaks, it is not sucking any air or leaking anywhere. Logs show flow up and down between 12 and 20, never hits 35 like it used to, injector DC is 100% at full throttle.

Is it possible that the pump is weak? It doesn't seem to shoot as vigorously as before when I jump the switch and dump into a container. Power and ground are good.

Thanks in advance.
__________________
RRT Racing
E92 335i/6MT Dinan Stage 3: intercooler, oil cooler, intake, flash, exhaust, LW dual-mass flywheel.
Vishnu PWM methanol custom trunk mount, Diffsonline 3-clutch Salisbury custom diff, Ohlins Road and Track coilovers, Vorshlag camber plates, much more...
E28 M5 w/ buncha stuff, R171 SLK350
JamesM3M5 is offline   United_States
0
Reply With Quote