View Single Post
      12-09-2012, 05:41 PM   #6
07lilredwagon
Lieutenant
 
07lilredwagon's Avatar
 
Drives: 07 328 wagon
Join Date: Dec 2012
Location: New York

Posts: 525
iTrader: (0)

Common practice is to clean all surfaces very very well before putting new o rings or rubber gaskets on. The comment about being sure the housing is seated properly is a sound one as well....

There could be a crack in the housing or cap itself, but this is probably unlikely.If you clean everything super well, you should be able to see exactly where the leak is coming from...keep an eye on it and check daily.

there are also some gasket sealers and adhesives that you can use to be sure the gaskets are seated properly and lined up to do their job well....

JP
07lilredwagon is offline  
0
Reply With Quote