View Single Post
      12-11-2012, 07:13 PM   #11
igorbmwx6
First Lieutenant
 
igorbmwx6's Avatar
 
Drives: 2011 BMW X6M 5.0 xDrive
Join Date: Jan 2012
Location: San Carlos, CA

Posts: 352
iTrader: (0)

Garage List
Send a message via Skype™ to igorbmwx6
Quote:
Originally Posted by makkan00 View Post
Blue wire is usually remote wire.
You should be connecting it to your car electrical system and not your laptop power cable. Some / most laptops work on 9 volts which will be less for DA2.
O.K. I got it (my mObridge DA2 programmed/configured and updated to the latest firmware). I tried to connect it to my McIntosh power amp and see if there is any sound. Apparently there is no sound. Is it possible that I also have to do some coding to my CIC unit in order for it to properly interface DA2? Any other suggestions would be greatly appreciated. I am trying to use the 8-analog channels from DA2 converter. Should I try to use the optical output from the DA2 and run it into optical input of my Audison BitOne and then input of my McIntosh power amp?
igorbmwx6 is offline   United_States
0
Reply With Quote