View Single Post
      12-12-2012, 09:44 PM   #15
E90 LCI's Avatar

Drives: '13 EBII 335i Bootmod3
Join Date: Dec 2009
Location: boca raton, fl

iTrader: (4)

Send a message via Skype™ to E90 LCI
Originally Posted by Kid Red View Post
There's a DIY around here that I used, can't find the link tho. Trim removal is in that thread and it's not that hard. Center console was all pull, the trim around the shifter popped up. iDrive was a cable disconnect, and then you angled the trim up and over the shifter (in N i think). It was pretty painless.

Get a large single sheet, amazon has it. I got 1080p CF from 3M. You'll need hair dryer, new exacto knife, towel/softer working surface. Amazon also has some 3M glue, in a small tube/stick form. That will help around the corners of the vents.

You lay the trim on the material, cut it's outline, then stick it. Once the face of the trim has the vynil, the corners are like xmas presents. The vinyl is plyable, flexible, so you need to heat, pull, then stick. You need to do that with the hair dryer and pull the vinyl flat, then stick it. You keep doing that until you have it flat.

Inside corners are the same concept, but they will have less material. The glue in the corners should help hold.

I've had mine for 6+ months in the FL sun, no probs so far. I took photos for a DIY, I just haven't gotten around to putting all my photos together. Here are a few.

Thanks for the input! I ordered the 1080 3m wrap (24"x60") and it was only 29.99 shipped. Should be here in a few days