View Single Post
      12-26-2012, 10:04 PM   #12
BimmerPost Supporting Vendor
Jeff@TopGearSolutions's Avatar

Drives: C6 Z06, GSXR-750, 09 335i
Join Date: Dec 2008

iTrader: (33)

Originally Posted by Blindside_137 View Post
All good info, and yes the sanding I think isn't necessary but also wasn't harmful either.

I did everything you mentioned though, I used alcohol to clean them after sanding. Let Dry. Temperature was about 60 F or so, and I was definitely atleast 8-12 inches away. Shook the can for a while too before spraying.

Followed it all to the T, just didn't work out.

I did notice my can wasn't sealed shut so I wonder if it had been used and then returned for the very problem I was having... Who knows, it is fine for now, may try to clean it up sometime in the future and change out the bulb for an LED. Live and learn..
That 60F could make all the difference just so you know. Ideally, you should put the can in some warm water and get the can up to temp. They are really sensitive to cold temps, and even when apply to cold materials (under 70F).

BLACK FRIDAY DEALS: 15% OFF ETS 5"/7" FMIC | Up to 30% OFF Evolution Racewerks | VRSF Black Friday $389 5" FMIC & $299 N54 Downpipes |

Wagner FMIC Black Friday Deals | $80 Off P3Cars VIDI | Remus Exhaust 10% OFF| AR Design Black Friday + Store-wide Coupon Codes and More!