Originally Posted by bv1
Excellent DIY, much appreciated. Did mine yesterday with this guide.
The only deviation I had was one step, which was to remove the PCV connection on the valve cover. I didn't see it mentioned above but it is a very minor step.. Also, I chose to use permatex high tack gasket adhesive to glue the gasket to the valve cover to make for an easy install.
Very good point actually, I have a occ so I just removed the hose and not he check valve. I thought about using a gasket sealer but did not want to clog the tiny air ways in the head.
JB4 G5, WEDGE flash, Walbro 455 LPFP, HFS-4 meth kit 4-AN SS lines, BMS OCC, RB turbos W/3.5 N20 sensor, RB valve, BMS DCI, 3" AR Dps, Custom OC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms W/upgraded bushings, M3 Strut Brace, M3 front sway, Meyle HD tie-rods, HPA rear toe arms, Wavetrac LSD, DEFIV kit, Ohlins R/T Cois W/12KG swift springs, Power-Flex subframe bushings, stoptech rotors, Rogue Tranny Mounts, Morr VS8.2 rims 245/295