Throwing Codes - Assistance - FBO
I had a chance to do some driving since the installs (ISO New Hex-C, and Intercooler) I am throwing a few codes, and hoping you can help:
jb4 iso - map 5 - settings as per Terry's post - newest firmware
ar 4 inch nocts
aa sport intercooler
e40 mix with 93
3BCC - PT-CAN, message (IHKA control unit):missing - ??????
36fd - see below.
DME main relay: implausibly open
The diagnostic function monitors the switch status of the main DME relay.
The fault is recognized when the switched status is implausible.Potential problem source(s): - Defect in wiring harness to DME main relay - Defective DME main relay
fault debouncing - Allow DME to enter sleep mode 3 times - will this fix the issue and if so, HOW CAN I DO THIS?
Voltage condition:- Onboard electrical system voltage between 9 V and 16 VTemperature condition:- NoneTime condition:- NoneOther conditions:- none
- Defect in wiring harness to DME main relay - Defective DME main relay
- Check wiring harness to DME main relay- Replace DME main relay
Last edited by geared; 01-01-2013 at 11:07 PM.