Upper & Lower control arm DIY question
I am installing a set of M3 Upper & Lower control arms tommorow and have 2 questions.
1. I believe you are supposed to have your suspension at ride height when tightening down the bolts to Upper & Lower control arms and obviously can't do that while it is on the ground. Do you jack each hub up or put the front and rear tires on ramps or what?
2. What are the torque specs?
JB4 G5, WEDGE flash, Walbro 455 LPFP, HFS-4 meth kit 4-AN SS lines, BMS OCC, RB turbos W/3.5 N20 sensor, RB valve, BMS DCI, 3" AR Dps, Custom OC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms W/upgraded bushings, M3 Strut Brace, M3 front sway, Meyle HD tie-rods, HPA rear toe arms, Wavetrac LSD, DEFIV kit, Ohlins R/T Cois W/12KG swift springs, Power-Flex subframe bushings, stoptech rotors, Rogue Tranny Mounts, Morr VS8.2 rims 245/295