Originally Posted by Cioringa
tried this but got an error
car still starts although i did have the dsc failed warning and dbc failed .... but after some DIS ajustment on the dsc it was gone...
looking in the UIF in INPA i can see that the DME is now marked as 7811921 so it is Alpina software or not ?
the programing stages were about 3 i think 0-100%i was promted 2 times that the ecu can be flashed 60 times then after the third stage i think got the error ...
the car runs normal from what i can tell ...
any ideea what happend ?
Try updating your ediabas files to 48.1