View Single Post
      01-08-2013, 09:55 AM   #7
antzcrashing's Avatar

Drives: 2006 330i
Join Date: Sep 2007
Location: Boston MA

iTrader: (1)

Garage List
2006 BMW 330i  [5.00]
Originally Posted by rjc03001 View Post
antzcrashing, when you cleared the code, did the airbag/seatbelt lights go out? Was all you did was clear the error in INPA?

GenePoole, was there an error associated with the loose battery terminal? If so, which category in INPA did it fall under and what was the error?
When I cleared the code I also got the airbag/seatbelt light to go out and this lasted for a 5 minute drive that night. the next morning, the lights reappeared. It was the only thing I cleared was the error in INPA. I believe I need to resolve the issue so it doesnt come back. I got the same error as:

ZK10 / Security battery clamp
Error will cause a warning light
Error is not currently present
Test conditions have been completed

I looked at the battery, which was recently replaced (2 mos again) and noticed that a cable is not connected on one end - the one which is electrically taped and zipped tied to the top of the battery, so I am assuming this is the airbag/seatbelt sensor and all I need to do it plug it in and then clear the code with INPA. If so I just need to find out where it plugs in. I will post a picture of the loose cable shortly.