Thread: Help...Rubbage
View Single Post
      01-09-2013, 12:19 PM   #13
Average Car Exceeding Expectations (ACEE)
ACEE's Avatar

Drives: 2007 335i e92
Join Date: Nov 2010
Location: Baton Rouge, La

iTrader: (7)

Garage List
2007 e92  [3.50]
Originally Posted by WilliamLAdams View Post
Found some from ECS Tuning. Is this a DIY install? Any instructions anywhere? I'm not very handy plus I don't have many tools here nor a lot of time (I'm in medical school).
Make sure to get the FK Bumpstops. I'm looking at ECS Tuning and looks like they have the bumpstops that are needing to installed from the top of the strut. FK Bumpstops have a slice that can just slide in. These are the bumpstops you need

Its really easy no major tools need. Just a jack, and maybe something to take your wheels off with...and a cold beer. You should be able to do this before finishing a beer. There is a sleeve that is on your struts, pull that down put the FK bumpstops in pull the sleeve back up...then repeat on the other wheel. I would also suggest using some axle grease or something and put on the bump stop. It is urethane and when rubbing against the strut rod will cause an ANNOYING rubbing/squeaking sound, the grease stops this. I hope it help

too much to list...just know its wide and low
instagram: @projekt_boogie