View Single Post
      01-10-2013, 05:57 PM   #356
cn555ic
BimmerPost Supporting Vendor

 
cn555ic's Avatar
 
Drives: Bimmerscoding.com
Join Date: Jun 2007
Location: New York

Posts: 18,267
iTrader: (5)

Send a message via Yahoo to cn555ic
The injector flow rates are predetermined and tested on the bench after its made to test the calibration of each unit. That flow rate value is given to each injector made as there are tolerances between each unit produced. That flow rate number from the INPA screen doesn't change if the injector starts to fail. It's only showing the calibrated flow of the injector which the dme will compensate for it to reach its desired flow.
__________________

Coding E and F New York 917-939-4980
cn555ic is offline   United_States
0
Reply With Quote