View Single Post
      01-16-2013, 08:08 PM   #80
HP Autosport
BimmerPost Supporting Vendor

 
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, Brembo, GIAC, Koni, Ohlins, Performance Friction, Quaife, Stoptech, Vorshlag

Posts: 11,079
iTrader: (29)

Quote:
Originally Posted by pits200 View Post
So what is the original geometry of the sway bar? There are multiple bends, is the final bend where the hole is suppose to be horizontal? Should it be tilted up slightly, down slightly or straight .
It's the end of the bar, that distance to the ground and the distance of the center of the center bushings to the ground, you want those two measurements as close as possible.
HP Autosport is offline   United_States
0
Reply With Quote