View Single Post
      01-17-2013, 10:18 AM   #26
drm916
Second Lieutenant
2
Rep
226
Posts

 
Drives: 335
Join Date: Jul 2012
Location: atlanta

iTrader: (2)

[quote=Manny_World;13323274]Can someone tell me the secret to get it perfectly lined up so I can put in all the screws? I've tried going left to right, right to left, and top to bottom.[/QUO

I had to remove the oil cooler shroud rubber gasket that sealed to the front of the regular bumper. It just comes right off the shroud. The shroud/ducting stays in place and is NOT removed. I only removed the small rubber piece. Its a piece of rubber and was about 4 inches wide and 3/4in thick. Once that was popped off it just went right on.

Try and figure out what/where its not fitting and address that area. I would look at the oil cooler shroud area and figure out if there is something going on there. Thats the only place where I could imagine there could be a problem.