View Single Post
      01-17-2013, 11:46 AM   #27
Manny_World's Avatar

Drives: e92 335i, e34 525i & e60 530i
Join Date: Aug 2011
Location: N Las Vegas

iTrader: (12)

Garage List
2007 BMW 335i  [4.17]
1994 BMW 525i  [5.00]
2007 BMW 530i  [4.33]
Originally Posted by Manny_World View Post
Can someone tell me the secret to get it perfectly lined up so I can put in all the screws? I've tried going left to right, right to left, and top to bottom.[/QUO

I had to remove the oil cooler shroud rubber gasket that sealed to the front of the regular bumper. It just comes right off the shroud. The shroud/ducting stays in place and is NOT removed. I only removed the small rubber piece. Its a piece of rubber and was about 4 inches wide and 3/4in thick. Once that was popped off it just went right on.

Try and figure out what/where its not fitting and address that area. I would look at the oil cooler shroud area and figure out if there is something going on there. Thats the only place where I could imagine there could be a problem.
Oh yeah, I remember you posted that before. I'll try that when I get home. I look right at that piece last night to, lol. Thanks!
"I'm Bad, and That's Good. I Will Never Be Good, and That's Not Bad. There's No One I'd Rather Be Than Me" -Wreck-It Ralph
Mods...Sparta Evolution\MFactory/Recaro\Macht Schnell/Evolution Racewerks\and more