View Single Post
      02-11-2013, 01:04 PM   #267
marconi118
Captain
 
Drives: 06/07 e93 335i
Join Date: Nov 2008
Location: europe

Posts: 955
iTrader: (0)

Quote:
Originally Posted by Nigelo View Post
You could just get the wings on the M3 centre bearing cut and new ones attached 10mm lower?
you could rotate the bearing housing so that the TOP marking goes down and add washers under the tabs so that the shaft is in line with the gearbox. don't know exactly how many mm washers

I would not solder the tabs, if thy break you are in danger of an explosion of the shaft....
marconi118 is offline  
0
Reply With Quote