View Single Post
      02-11-2013, 01:12 PM   #269
Nigelo
Lieutenant
 
Drives: E92 335i se
Join Date: Aug 2011
Location: Northern Ireland

Posts: 528
iTrader: (1)

Quote:
Originally Posted by marconi118 View Post
you could rotate the bearing housing so that the TOP marking goes down and add washers under the tabs so that the shaft is in line with the gearbox. don't know exactly how many mm washers

I would not solder the tabs, if thy break you are in danger of an explosion of the shaft....
I like your idea much better than mine!


Just so I know Marconi, was your measurement like the red or blue line (ie straight, or parallel) in my piccy? Thanks!
Attached Images
 
Nigelo is offline  
0
Reply With Quote