Thread: Bad JBD Unit?
View Single Post
      02-21-2013, 01:17 AM   #5
diaz92376
Second Lieutenant
 
Drives: 2011 335d
Join Date: Jan 2013
Location: So Cal I.E

Posts: 233
iTrader: (1)

Quote:
Originally Posted by FormerRotor View Post
This sounds like what I've seen when the JBD was not entirely clicked in to the sensor. Sometimes if your placement isn't right you can hit the clip when you replace the Engine cover. I would try to reconnect, triple-check the connections, the. Start up. If it continues and only happens when the JBD is plugged in, then take it out & call burger. I'm sure they'll replace it for you if it is, in fact, defective.
I zipped tied it just to be on the safe side since i was hoping it was just a lose connection but no change. As far as calling the company I'm pretty sure I'm out of luck since i bought it used from a member on here.
diaz92376 is offline  
0
Reply With Quote