View Single Post
      02-28-2013, 02:31 PM   #8
FRG530
Lieutenant
 
FRG530's Avatar
 
Drives: F10 530d
Join Date: May 2012
Location: east midlands

Posts: 536
iTrader: (1)

Quote:
Originally Posted by sparkie View Post
Only problem here is there is no control, heating on in conservatory will only be regulated by house room stat. I'd fit motorised valve on the circuit branched from the original and fit another stat in conservatory. So on a sunny day you can have heating on in house but conservatory switched off and soaking up the suns rays through the glass.

Buy a zone valve and roomstat and throw the heating pack away. Where and why do you have a blending valve? No need as that would cool water..
I wasn't sure if I could do this or not. I didn't know if the UFH needed a pump and manifold. If I can just run it from an MOV teed into the existing CH controlled via a room stat in the conservatory then that's all good. Will the boiler cope with the extra load though? This is an example of what I was looking at: http://www.ebay.co.uk/itm/Underfloor...item5adf6d3aaa
__________________
FRG530 is offline   United Kingdom
0
Reply With Quote