View Single Post
      04-08-2013, 09:30 AM   #1
kavadarci
Lieutenant
 
Drives: 335xi
Join Date: Apr 2012
Location: canada

Posts: 564
iTrader: (0)

Interesting question

I hope someone can answer this for me.
I have THREE leds that are not working on my right turn signal which drops the resistance and causes an error on the dash and forcing the turn signal to flash faster.

SOOOOOOOOOOOOOOOO,
Instead of dropping good amount of money (out of warranty here) on new tail light, can I install load resistor (same as the one used when you replace regular bulbs with leds) and "trick" the system that I do have the correct load?

This should not cause the fast blinking and the error, the only drawback is i have three less leds blinking in the back, WHICH I would be fine with.

Thank you.
kavadarci is offline  
0
Reply With Quote