Originally Posted by Augster
I actually didn't realize there are TWO very similar threads started on this site by the same OP with the same material; the "other" thread only at 11 pages but divergent with mostly different types of posts.
Anywho, I followed Dracon's posts #265
and installed a 2011 GSM TCU, 2011 FZD with mic, plus requisite supporting components. Simply repowering the vehicle with no programming whatsoever I got telephone, voice recognition, and Bluetooth running and was able to pair my phone and make/receive calls, but the mic is not working.
I've read about many experiencing non-functioning mics requiring wiring/connection modifications, but it seems this is for MULF-only Bluetooth retrofits.
My US non-iDrive 2008 335i has 640A Telephone prep and 6FLA USB/Audio Interface, meaning it already has a MULF with Bluetooth. I believe this is the source of the mic issue and hopefully should be fixed with proper programming.
But I've never coded any VO's before; just registered a new battery with the same specs.
I am assuming I need to add VO $639 to CAS and NFRM, but do I need to manually remove VO $644? Are there any other modules I need to code? I've read and watched the 2RAD being coded, but this appears to be with MULF-only retrofits so I don't know if this is necessary for TCU retrofits.
Do I need to do any other coding and/or SG_RESET? And if so, what are those actual steps; remember, I'm a noob so I need explicit instructions!
I think, but I'm not sure, if you installed a TCU that takes over telephone functionality from the MULF. If that's true, it may require rewiring the mic to the TCU instead of the MULF. If it's not true, I don't think there's any reason you needed to buy and install the TCU (unless you want BWM Assist).