Quote:
Originally Posted by oldbmwreader
You're missing a step. Here's what you do:
1. Add +MUH2 to BOTH your CAS and your FRM VO.
2. After that, Set your job to SG_Codieren.
3. Set the job module to FRM.
4. Execute job.
This will reset your FRM to default settings based upon what your VO is. If you have an FRM3, you will have zero errors. If you are getting errors immediately after doing this, you either did something wrong, or you do not have FRM3.
If you have FRM2, replace +MUH2 with +MUEB and do the exact same steps. If you have errors after that you did something wrong.
This thread will cover all steps here |
Thanks so much! That was the step I missed.
I had the VO added to CAS and NFRM but forgot to the code NFRM back to default.
I lost a few things I coded before in NFRM, but those were easily added back.
Once I did that everything worked perfect, so much easier than manually doing all those checks.
Plus the new VO added new lines related specifically to LED taillights to the NFRM module. I did a trace file compare in NCS dummies and saw all the new entries. This is definitely the correct way to do it.
Thanks again!