Quote:
Originally Posted by Persian Whisperjet
Quote:
Originally Posted by compressionignition
Can't stress enough how important this is, had an x5d in my shop last week that was setting fuel pre-supply faults due to a clogged fuel filter.
Having some type of diag tool (autologic, autel, or equivalent) is good as well in order to run the bleed procedure post-filter change. The tool runs the in tank pump for around 2-3 mins, and then prompts you to start the engine and runs the car at 2000ish rpm for 10 minutes. Change filter with a somewhat warm engine to avoid having to let it sit at that high rpm range when cold during bleed procedure. Can also just start vehicle and put something heavyish on the go pedal for a bit as long as you can get it to hold steady. Improper bleed will leave you long cranking for a few starts with air left in the lines.
|
Very interesting. I did mine last weekend and used the Autel to activate the lift pump for 120 seconds. What is the logic of running the engine for 10 mins? |
Quote:
Originally Posted by Persian Whisperjet
Quote:
Originally Posted by compressionignition
Can't stress enough how important this is, had an x5d in my shop last week that was setting fuel pre-supply faults due to a clogged fuel filter.
Having some type of diag tool (autologic, autel, or equivalent) is good as well in order to run the bleed procedure post-filter change. The tool runs the in tank pump for around 2-3 mins, and then prompts you to start the engine and runs the car at 2000ish rpm for 10 minutes. Change filter with a somewhat warm engine to avoid having to let it sit at that high rpm range when cold during bleed procedure. Can also just start vehicle and put something heavyish on the go pedal for a bit as long as you can get it to hold steady. Improper bleed will leave you long cranking for a few starts with air left in the lines.
|
Very interesting. I did mine last weekend and used the Autel to activate the lift pump for 120 seconds. What is the logic of running the engine for 10 mins? |
I can't comment as to the logic of the ten minute run but the main point as I understand is to bleed air from the fuel system after the supply line from the tank is open during fuel filter replacement. If you are using ISTA or any tool capable of running BMW service functions the function listed as "bleeding fuel system" or something along those lines runs the in tank fuel pump for around three minutes and then instructs you to start the vehicle, at which point the service function holds the engine speed at around 2000 rpm and tells you to let it run in this condition for 10 minutes.