- Checked the positive cable going into the wheel well. No signs of a bad wire.
- removed the IBS to see if this would temporarily resolve the issue, no luck.
- removed the battery safety terminal on the positive lead and checked. Noticed the prongs that connect the safety terminal and the blue connection had some slightly burnt ends (wiped off and put back together) still no power.
- removed the glove compartment to gain access to the fuse box and junction box. Removed the junction box and fuse box to inspect the B+ cable in the back. No signs of a faulty cable. I believe the cable already completed the recall (it had the black heat shrink wrap around the cable). Checked the cable with my multimeter and was showing power. Put back together.
- checked fuses with a fuse light, no fuses showed any light. Checked fuses with my multimeter for continuity, all fuses were fine.
- checked ground cable under driver right side. Cable looked good still.
I don’t really know what else to check or do. I am planning on replacing the the battery safety terminal, if that does not do anything then I will replace the junction box.
If anyone else has inputs, please let me know. It would be greatly appreciated.
