New HPFP, HPFS, LPFP,LPFS and now getting 2AFF code?
Alright you legends hope you're all doing super good,
Car E92 n54 2008
I've just finished fitting an OEM HPFP, OEM LPFP, updated the LPFS with the updated sensor and adapter
Also a new HPFS
Reason for new Parts - car hesitated and lost power, reset adaptions and managed to get home in Limp Mode
Next morning started up fine, Idled & Reved normally didn't drive it though!
Codes I was getting before
2FCA Fuel High Pressure
2FDA Fuel High Pressure
Plus an ongoing
29E1 DME mixture control 2
Ordered the parts the following week
Installed the parts yesterday, started up fine took it for a test drive did a few 3rd gear WOT runs all seemed good,
Turned the car off and started it back up rough idle for 10 seconds and ran fine (on going issue in relation to 29E1
No other codes
Covered around 300kms and filled up the tank with 91oct at the shell garage, covered a further 60kms
Checked for codes and got these
29E1 (consistant) possible map sensor
29F4 Catalytic converter conversion
29F5 Catalytic converter conversion 2
(Possibly all the ethanol in the gas out here)
2DED power management closed circuit violation
Possibly due to leaving my OBD cable plugged in
Shadow code
2AAF Fuel Pump Plausibility
If you guys have any ideas that could help I'd be forever grateful
Car drives fine
|