View Single Post
      08-16-2008, 09:04 PM   #24
smallseafishie
Lieutenant Colonel
21
Rep
1,739
Posts

 
Drives: AW 07 e92 335i + AW 11 X5 35d
Join Date: Jun 2007
Location: Atlanta GA

iTrader: (12)

Garage List
2007 E92 335i  [0.00]
Instructions on removing back seat

Wow... the back seat part took some the longest amount of time since we (me and a friend) had no idea what to do. The instructions did not mention how to do this outside of the generic remove rear seat message.

To make this worse, his car did not have flip down rear seats....

So... heres a word of advice to pass on to the next person doing this install to save time.

To take apart the rear seat, lay down in the trunk and look up at the rear deck. There should be a total of 4 12mm nuts that must be removed (2 on the left, 2 on the right). These screws are for the latch that holds the back seat down. Then... for the rear seat bottoms, pull up at the front and pull forward to remove. Then, in the center towards the bottom of the bench, there are 2 T45 hex screws that need to be removed. Then, pull the rear bench slightly upwards and forwards to remove.

To re-assemble the seats, just remove the two latches to the rear back seat bench and screw them back into place with the 4 12mm nuts. Then place the seat back into place and let them snap in. Then tighten the 2 T45 screws back on and rear seat bottom.

That should be it...


Oh - and another thing that wasn't so evident, for the part of removing the 2 fiber optic bundles apart, the latch that needs to be moved is actually on the left hand side of the thing (left hand side if you were looking at it directly).