Originally Posted by wuufer001
after i finished installing and putting back the screws, there was one screw (the one that holds the rubber piece at the far end) that didn't want to go back. It felt like there is no housing for the screw. so it just falls off when i try screwing it. what may be wrong? Its just so spacious/loose.
I think I may know which one you are talking about.
Are you talking about the very last screw at the far side(towards the engine/middle of the front end) where two plastic panels supposed to meet together in order to put the screws in?
If yes, you just have to align those plastic pieces properly to get them screwed in. I had the same trouble. Just took some time. Might be a little tougher without seeing the actual bottom plastic pieces though.