View Single Post
      10-15-2006, 05:27 AM   #2
Hong Kong

Drives: F10
Join Date: Apr 2006
Location: Hong Kong

iTrader: (0)

Garage List
2012 BMW 528i  [4.25]
2006 BMW 325i  [0.00]
Then you need to solder the 3 resistors to the housing. I am running them in parallel. Since the two lights are running in parallel, it doesn't matter where you install the 3 resisters. For the cable length, 30cm is good enough.

I put two to the left housing and one to the right housing.

In first photo, you can see a small resister at the right. It is actually good enough to just use this one. However, it will gets very hot. For safety, I divided the load to 3 extra large resisters.
Attached Images

Last edited by rikuF10; 10-15-2006 at 06:15 AM.