Thread: Help Procede
View Single Post
      07-14-2009, 04:34 PM   #10
shiv@vishnu
Tuner
 
Drives: X1, 335i
Join Date: Sep 2006
Location: SF Bay, CA

Posts: 17,616
iTrader: (0)

Quote:
Originally Posted by boxter View Post
Hi!!

I am sure it says "connected to procede" at the bottom, and when the engine symbol iluminates, do I look in the right window in the DME Diagnostic Codes channel? I donīt see changes in this channel, although in other channel I see readings of throttle for example. Must I have some codes when I update the firmware? Even when I did it, I didnīt see nothing. Can I force some code to check that all works correctly?
Nope. If you have no code, you have no code.

Quote:
Shiv today updated the firmware to 125, I noticed in valet mode less energy, is it possible?
No. Not possible.

Quote:
Now in valet mode is there less gas consumption than stock?, I remember that you told me.
Nothing has changed with respect to valet mode. It is just like that of a stock vehicle. Fuel consumption and all.

Quote:
Today I am to 800metres, but yesterday with firmware 123 I was to 0 metres ( I could see the channel "wastegate DC limit= debug word 4" to 50-51 in the sea level but in Madrid to 800m the channel is on 45. Is it the reason?
Yes. Higher altitude will require more boost DC to hit the same absolute pressure target.

Quote:
Shiv other thing: what is the channel to read the real opening of intake air valve.
It's the parameter called 'CAN DBW Throttle" DBW stands for Drive By Wire. This will all be explained in the custom tuning documentation I'm currently writing.

Shiv
shiv@vishnu is offline   United_States
0
Reply With Quote