Originally Posted by leetennis
Hi guys just been reading through the thread, just to clarify there are no splicing points in the front door sill, best points are to enter at the 4 plug connecter... if you have the LCI
I have the 4 door saloon will i have to bring up the rear door sills too?
thanks all, getting it all straight in my head before going for it.
Hi, I can confirm that you need to remove the front seats to expose the connectors to the sub as there are no splicing points (well i couldnt find any!)
You will need to remove the rear trim so you can route the cable from the rear to the front of the car. It just clips out so its not a problem.
The only other thing I found different was the earth point. It didnt seem to be where the instructions said. There was one directly below the boot opening. Or maybe you could go direct to the battery?
Its a lot easier than you think. Just be careful removing the door cards. I used a screw driver wrapped in insulation tape so not to scratch anything.
Good luck, you won't regret it