View Single Post
      02-24-2010, 11:54 PM   #95
Rob@RBTurbo
BimmerPost Supporting Vendor

 
Rob@RBTurbo's Avatar
 
Drives: 335I
Join Date: Jan 2008
Location: St. Louis, MO

Posts: 1,052
iTrader: (4)

Shaft and wheel are one piece. Its not as simple as inserting a higher quality shaft only in the centersection... you have to make the Turbine wheel/shaft combo work. Unfortunately this wheel is just very small, and if you use it you are stuck with a tiny shaft.

Quote:
Originally Posted by GreenPlease View Post
Excuse me if this is an ignorant idea but if the turbine shaft proves to be too weak couldn't we just replace it with a titanium shaft of the same diameter? Seems like that would only cost $40-50 in any sort of quantity. Could apply some low friction ceramic coating to it while you are at it.
Rob@RBTurbo is offline  
0
Reply With Quote