View Single Post
      02-26-2010, 05:57 AM   #2
Former_Boosted_IS
Major General
143
Rep
5,179
Posts

 
Drives: 4 Wheels
Join Date: Aug 2007
Location: Planet Earth!

iTrader: (15)

Quote:
Originally Posted by klipseracer View Post
As a procede user, can anyone think of a way to monitor IAT's on a 52mm gauge? I know there are gauges out there but I don't know what type of signal they take as input nor do I know what signal is output by our ecu. Has anyone tried this before without a JB3 and BMS tuning gauge? If not, does anyone have any thoughts here? This is a very valuable stat to monitor for us Meth users. Flow rate and IAT's are my main goal at the moment.
This has been extensively tested and I am not sure there is anything to gain at this point. Monitoring flow in my opinion is basically the only thing that matters so that you know what you are flowing. Here is a video of an IAT guage next to a flow guage during a dyno run.