View Single Post
      03-28-2010, 05:18 PM   #101
Drives: 06/07 e93 335i
Join Date: Nov 2008
Location: europe

Posts: 962
iTrader: (0)

Originally Posted by tvieira24 View Post
Sounds like he used the 335 first half of the driveshaft then used the m3 second half from the first section to the differential. I'm assuming the M3 subframe places the differential a bit closer to the trans than the 335 which is why it was necessary to shorten it.

Personally I'd prefer to go with a DCT M3 and keep the full M3 driveshaft with an adapter on the transmission side.
He uses a M3 LSD on the 335i subframe.
I will use the M3 subframe, so that the mid shaft bearing will go to the right place under the car if using an M3 shaft
marconi118 is offline  
Reply With Quote