View Single Post
      04-02-2010, 11:51 PM   #1
Brigadier General
scottp999's Avatar

Drives: 335i - E92 - 6MT & 4runner SR5
Join Date: Mar 2007
Location: MD

iTrader: (2)

Garage List
2007 BMW 335  [4.50]
Anyone change springs in new style forge diverter valves?

I can't get anything on there to twist open. It's not like the old style where it was obvious and easy to open up. Anyone have any hints to get it open? It looks like the opposite end from where it used to open on the old style is where it would turn, but I can't get grip on it.

I want to put the yellow springs in.

**namotorsports added on to the bottom of the forge instructions for the new style. You can see a picture of what I'm talking about at the bottom of this document:

I can not get that base to twist at all.
Attached Images
Rob Beck Turbos, PROcede Rev. 3, Procede Fueling Flash (via OpenFlash Tablet), PPS Methanol System (Devil's Own 12 GPH Nozzle/Aquamist Flow Sensor/Labonte VC25), DCI, Quaife LSD, BMW Performance Suspension, Autobahn Exotics Exhaust, Helix FMIC, AR Design Downpipes, BSH Catch Can, RB PCV Valve, Forge Diverter Valves, P3cars Vent Boost Gauge, Alufelgen CSL Reps, Lux 5.1 H8 Angel Eyes, HPB HID Fogs, LTBMW M3 Side Skirts, BMW M3 Rear Spoiler, BMW Front Aero Lip, BMW Pedal Kit, BMW M Shift Knob, Autotecknic Matte Black Grilles.

Last edited by scottp999; 04-03-2010 at 12:49 AM.