View Single Post
      04-05-2010, 08:15 PM   #12
Second Lieutenant
blitzkriegF82's Avatar
Drives: over yer lawn.
Join Date: Aug 2009
Location: Kelowna, BC

Posts: 249
iTrader: (4)

Originally Posted by ********* View Post
I cut the vinyl so that it overlapped the seals about 1/8 inch. Then using a heat gun, I ran it along the edge and used the squeegees and a small screwdriver to wedge/lift the vinyl/seal, respectively. This way I didn't need to cut the vinyl straight for it to look good because it went under the seal.
Thanks! I have had a role of this stuff for a couple of weeks now and didn't do anything with it because I was unsure of how to get it under those properly.
blitzkriegF82 is offline   Canada
Reply With Quote