View Single Post
      07-11-2010, 03:26 PM   #1
burningchicken
Lieutenant
 
burningchicken's Avatar
 
Drives: 2007 e90 335i
Join Date: Jan 2010
Location: noVA, Virginia Tech

Posts: 430
iTrader: (5)

Question about the free bov diy

I would have posted in the diy thread, but I figured I would get a better and faster response here.

I did the free BOV diy and just wanted to make sure that I did it correctly since there was only one picture in the thread.

I purchased two 3/4 inch plugs from homedepot.
http://www.homedepot.com/h_d1/N-5yc1...atalogId=10053

These did NOT fit however. I had to flip it around and use the square part to plug it, which actually fit quite well. I did not use electrical tape because it made it slip out more easily.

The blow off noise produced is noticeable, but barely. Perhaps my BMS DCI has something to do with it?
Perhaps placebo?

Here are some pictures. If I did something wrong, please tell me. Thanks!
Attached Images
    
burningchicken is offline  
0
Reply With Quote