View Single Post
      03-20-2007, 10:27 AM   #113
uhaulball
0
Brigadier General
 
Drives: e90 330xi
Join Date: Dec 2005
Location: Long Island, NY

Posts: 4,164
iTrader: (11)

Send a message via AIM to uhaulball
i guess it wasnt made very clear.

1. Undo the 2 inside clips of the rear fog button Faceplate.

THEN!

2. Bend off the 4 tabs on the faceplate, when in your hand. These four tabs are not connected by any means to the actual light switch unit, it is only 4 small protrusions on the faceplate preventing it from going inward, but not actually holding it in place. The two interior clips is what holds both the front fog light button and rear fog light button. once u take off the faceplate, and remove the four tabs, then slide it back in. It now slides on its track like the top button.

3. Obtain/Fabricate an extra "white" piece.

Dont saw off the 4 tabs when the faceplate is still attached to the unit, thats just a pain in the ass and i quickly dismissed that possibility when i was figuring out the proper way to go about this DIY.
__________________
'06 bsm e90 330xi : 18" VMR CSL : KW V3 : GruppeM Rep Intake : UUC/Corsa Catback : Hartge Lip : ACS Roof Spoiler
OEM CF Trunk Spoiler : CF Emblems. Pillars. Mirror. Grille : LUXER12 led plate : V1 Hardwired : OG.longtran e90post sticker! circa 2005
uhaulball is offline  
Appreciate 0
Reply With Quote