View Single Post
      03-20-2007, 12:29 PM   #115
txusa03
Major General
 
Drives: TS330iPPSP6MT
Join Date: Jul 2005
Location: Planet Earth

Posts: 6,567
iTrader: (2)

Quote:
Originally Posted by uhaulball View Post
i guess it wasnt made very clear.

1. Undo the 2 inside clips of the rear fog button Faceplate.

THEN!

2. Bend off the 4 tabs on the faceplate, when in your hand. These four tabs are not connected by any means to the actual light switch unit, it is only 4 small protrusions on the faceplate preventing it from going inward, but not actually holding it in place. The two interior clips is what holds both the front fog light button and rear fog light button. once u take off the faceplate, and remove the four tabs, then slide it back in. It now slides on its track like the top button.

3. Obtain/Fabricate an extra "white" piece.

Dont saw off the 4 tabs when the faceplate is still attached to the unit, thats just a pain in the ass and i quickly dismissed that possibility when i was figuring out the proper way to go about this DIY.
Thanks for those clarifications...keep them coming (ideas or clarifications)...
__________________
under construction!
txusa03 is offline  
0
Reply With Quote