View Single Post
      11-06-2010, 05:48 PM   #48
enrita
0
Major General
 
enrita's Avatar
 
Drives: 335i - Big turbos
Join Date: Sep 2008
Location: Italian in Sweden

Posts: 7,323
iTrader: (0)

Quote:
Originally Posted by shiv@vishnu View Post
Quote:
Originally Posted by enrita View Post
would not mind use those 2 channels with my AEM EGT and AFR probe.
Only 1 input is freed up. The other is an output. So you can certainly feed one of those sensors into the Procede. Just not both (at this time). There are some firmware changes that we an do that can free up another input and output. But that's not until later.
Ok so i could just connect that EGT signal to the procede and read it?
Basically there is nothing to do on the firmware side?
Since i will put high flow cats in 2 weeks i could weld the bung than.
__________________
07 335i AT - TD St.2 Turbos - COBB (Custom Cobb mapping by http://www.protuningfreaks.com/) - JB4G5 ISO - Okada Coils - NGK 5992 Plugs - E85 Walbro - Injen Intake - Helix IC - Snow Stg. 3 - Stett CP - AR DPs - midpipes 100 HJS Cats - Bastuck Quad - PSS10 - QUAIFE LSD - BMS OCC - Forge DVs - AR OC - ALCON BBK - M3 Chassi - Dinan CP - Velocity M rear Toe arms - Advan RZ-DF - Level 10 AT upgrade - Alpina AT Flash
enrita is offline   Sweden
Appreciate 0
Reply With Quote