View Single Post
      11-06-2010, 05:51 PM   #49
shiv@vishnu
 
shiv@vishnu's Avatar
 
Drives: PROcede v5
Join Date: Sep 2006
Location: SF Bay, CA

Posts: 17,609
iTrader: (0)

Quote:
Originally Posted by enrita View Post
Ok so i could just connect that EGT signal to the procede and read it?
Basically there is nothing to do on the firmware side?
Since i will put high flow cats in 2 weeks i could weld the bung than.
There's really not any update required in the firmware if you want to feed a standard 0-5 volt signal in the Procede. Just a couple small changes to the logging setup which I can describe via email.

shiv
shiv@vishnu is offline   United_States
0
Reply With Quote