Just wanted to put up some updated pics. You'll see that they've started working on some of the points that we mentioned before. Just to recap:
1. The extrusions over the exhaust are being made smaller so that they don't stick out over the exhausts.
2. The profile of the exhaust covering section is also being made to match the profile of the fins.
3. The "cavities" betweent the fins are being made deeper so that
4. The fins will be made longer without them havig to protrude any further from the main profile of the diffuser.
From a timing perspective, the final pattern will be ready next week Wednesday - from which a mould will be made and the first prototype part can be pulled. If all goes well I should have a prototype on my car within 2 weeks.
Questions / comments etc?