View Single Post
      02-10-2011, 02:03 PM   #1
HP Autosport
BimmerPost Supporting Vendor

 
Drives: E82 1M
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Quaife, Stoptech, Vorshlag

Posts: 10,914
iTrader: (29)

Another set of KW springs going into the dumpster!

We are converting yet another set of KW V3 with Swift springs, this time with the request of the owner to install helpers springs. No camber plates were requested as the car is strictly a daily driver for the time being. The additional negative camber needed to reduce understeer will come from the slight lowering of the car and M3 wishbones and proper selection of spring rates. We settled on 400F and 800R for this particular project.

With the installation of Swift springs and thrust sheets some of the noise that has plagued the KW V1, 2, 3 or even the CS may be a thing of the past.

As you can see the use of Swift springs make the front coilover over setup more compact and lighter by about 2 lbs.
Attached Images
  
HP Autosport is offline   United_States
0
Reply With Quote