View Single Post
      03-20-2011, 12:22 AM   #14
hotrod182
.
 
hotrod182's Avatar
 
Drives: 07 335i, 06 M3
Join Date: Dec 2006
Location: California

Posts: 3,461
iTrader: (0)

Okay, so just finished plumbing for an additional meth injector. I'm still running the CM10, but I added a second slightly smaller injector. As you can see in the picture, I installed a control valve to the second meth injector. This way I can test it on the single CM10 on back to back runs, and then open the valve and see the difference (if any) that the second injector coming on line will make.

Today I removed the intake pipe and individually test fired them just to make sure the spray pattern was sufficient. I was concerned the the CM10 was too far recessed into the bung. Turns out the spray pattern is fine.

Attached Images
 
__________________
2011 Alpine 335d M-Sport 12.34 @ 110.48mph
2012 LEAF 130MPGe
2008 Black 335i Sedan. 11.11@ 129.47 mph,(8.39 sec 60-130 stock turboWR)
2008 Monaco Blue JB3 2.0 335i Coupe. 11.33 @ 132.77 mph (N54 trap speed WR)
60-130mph: 6.95 seconds stock turbo WR (.16% slope)

Last edited by hotrod182; 03-20-2011 at 12:45 AM.
hotrod182 is offline  
0
Reply With Quote