|
Should provide a bit of an update...
It's going to be all cf now with aluminum as a stiffener. This is something where the weight and strength of CF is required. There are two points on the rear bumper that is directly attached to the frame. I'm spanning that with an aluminum frame and then the CF is attached to that.
Going to start small on this and work my way out. So right now it's just a piece that will hang under the bumper (or m-tech diffuser) and in the future, it'll probably extend out.
The 3D models have been done up, needed to make some changes and the drawings have been sent to the factory for manufacturing already. Will post up some renders tonight. Hoping the finished product will arrive in the next few weeks and then I'll post up the pricing for it.
|