Quote:
Originally Posted by 2010_328i
... Recently, I acquired a 2010 328i sedan that cranks but does not start... So far, I have replaced the following
with new parts:
Crank Position sensor
(2) Camshaft sensors
(2) Solenoid sensors [VANOS Solenoids?]
The car cranks but does not start. If left for a day or two and reattempt to start, the first initial crank sounds like the
motor wants to catch. Subsequent start attempts result in continuous crank without sounding like it wants to start...
The codes that I have are:
P0015 (Exhaust "B" Camshaft Position Timing - Over - Retarded Bank 1)
P054B (cold start B camshaft)
P0365 Camshaft Position B Circuit
Chris
|
Those 3 Fault Codes suggest an issue with the Exhaust Cam Position Sensor wiring/ connectors between the Sensor,
Connector X6224, & DME Connector X60007. See the attached ISTA wiring diagram & Connector Location/Views.
If suggestions for TESTING with Multimeter or whatever Scan Tool/ diagnostic software you have are desired,
please advise, & provide Make/Model of Scan Tool or Software.
Here is BMW Fault Code Lookup Definition of "2AA1" & LINK to Fault Info Sheet (See Service Notes):
P0365 | 2AA1 | DME: Camshaft sensor, exhaust, signal | MSV80 | Engine electronics
https://bmwfault.codes/XMLDiagView?d...MAOQA4ADAANAA=
George