|
hi - i have spent weeks of evenings reading through forums trying to understand what i have to do to enable my retrofitted bmw bluetooth kit. after two sets of cables and software i can make changes to the ecu's on my 2008 e90, i have now got TEL on my profressional radio (no idrive) but without the phone picture. I found a link on you tube showing rad2 ecu being updated - bluetooth_RAD2 active and ULF_ECE active. I have since added the temp speed when the cruise is actived using ncs 4.01
Do i need to add $644 and $633 to my VO or have i just achieved this another way ? i have tried following a pdf to alter vo but the "back" is missing and if i ignore the list is empty. I finally got the list up added $644 and $633 hit ok but when i hit back "error 1000" in german and i'm stuck again.
Ive run INPA and i can't see ULF listed so i need to get this seen.
can anyone help ?
has anyone fitted one of these bmw retrofit kits - MULF cables cradle, antana and mic with wiring?
|