Shiv-
When i did this earlier today, the car start and ran fine. I went for a ride to Walmart and when I got back out to start the car, it went to a limp mode. The engine start to shake and the car shut down. I started the car again and the same problem but when i give it a little gas, its was fine. What do you think the issue is? The connection looks exactly like yours and I only removed any unused pin.
The Injectors, plugs, and wastegate was replaced in October. I'll run the computer tomorrow to check for the error.
I have AMS IC, DP, Intake, Procede v4.
Any help would greatly appreciated.
|