I just loaded 1.45 and have some quick points based on my experience: 1. Make 100% certain your serial cable is plugged into the Procede. I thought mine was yesterday when I did this, but it wasn't. It should slide in to a click almost--give it some force (without pulling the wires on the procede) to assure it is inputed all the way; 2. Set the Coms link in the engine control software (the new version, under the menu item "Coms"); if you don't know your computer's Coms link, check under your device manager where you should find your cable identified; and 3. After all of that, go back to the Coms menu and select "Go Online/Offline". Then, the map will load up, assuming you loaded it into the software beforehand; if you didn't do that, open it now and it will load.
Going for a drive now!
|