Quote:
Originally Posted by SROC3
Acutally, i do care quite a bit, thanks orb for your insight. Now, what does that mean in layman's terms?
And is there a loss in low-end power from this mod AT ALL? There seems a lack of "sure" knowledge on this point. i took it off and then re-attached it after 2 weeks or so. What's your take on this modification?
|
The mod will not reduce power. If anything power and response should increase. It is a restrictive device and it only purpose is to reduce noise at low RPM. I like the sound a lot better now.
From my own experiences the pressure and vacuum forces will not move the ball bearing. I don’t think you have to pin prick the hose to equalize to atmosphere pressure but it is a good idea and would recommend it.
I made a small hole in the hose so it does vent/suck when tested. You can’t even see the hole and it not going to leak in water or dirt.
Orb